Specification

Sales & Specifications Sheet • Issue Date July 2014
www.sharkbite.com · 2727 Paces Ferry Road · Building 2 · Suite 1800 · Atlanta · Georgia 30339 · USA
US Contact: 1-877-700-4242 · [e-mail] · Canadian Contact: 1-888-820-0120 · [e-mail]
A Division of Reliance Worldwide Corporation
SharkBite
®
Slip Ball Valve
TYPICAL INSTALLATION
CONNECTIONS
SharkBite ....................................... 1/2” through 1”
CERTIFICATIONS
The SharkBite Slip Ball Valve 1/2", 3/4" and 1” are certified to IGC-157/NSF61 and NSF 372
and listed by IAPMO.
Dimensions
A
B
1/2" (24735LF)
3.88
3.80
3/4" (24736LF
4.50
3.75
1" (24737LF)
5.50
4.75
Cut out the section of pipe
 For ½”, remove 2.00”
 For ¾”, remove 2.25”
 For 1”, remove 2.50”
Using the SharkBite Deburring &
Depth Gauge (U702), clean the
edges of the copper pipe and
mark the proper insertion depth
on the pipe.
On the side of the valve marked
“SLIP END”, slide the copper
pipe into the fitting until it
bottoms out.
Place the SharkBite Disconnect
Clip on the copper pipe, on the
same side as the “SLIP END”.
Press the clip to release the
fitting and slide the SharkBite
fitting to meet the other pipe.
copper pipe.
Continue to slide the fitting until
the non-slip end reaches the
tube stop. Ensure that the fitting
lines up with the depth markings.
To disconnect a fitting, push the
disconnect clip against the
release collar. While pushing
against the release collar,
remove the pipe from the fitting.
1
2
3
4
5