Install Instructions

5
MAKING A SHARKBITE
®
UNIVERSAL CONNECTION
Making a SharkBite
®
Universal Connection
When cutting SharkBite PEX Pipe, ensure that the ends are cut
square and the surface is smooth. Ensure that both the PEX pipe and
fitting are clean and free of dirt and debris in preparation for making
a connection.
STEP 1
Insert the pipe through the release collar to rest against the grab ring.
STEP 2
Push the pipe firmly with a slight twisting action until it reaches the
tube stop. To ensure that the pipe is correctly inserted, check that the
depth mark is within 0.005 in (0.13 mm) of the end of the release
collar.
NOTE: Install SharkBite push-to-connect fittings at least 1” apart to enable
disassembly of the joint.
STEP 3
1. Place the SharkBite disconnect clip around the pipe with the
non-branded face against the release collar. If using the SharkBite
disconnect tongs, place the teeth around the fitting assembly.
The fork end with the SharkBite brand logo should be positioned
around the pipe and the other end around the neck of the fitting.
2. Push the clip against the release collar and pull the pipe with
a twisting action to release the pipe. If using the SharkBite
disconnect tongs, squeeze the tool with one hand and pull the pipe
with a twisting action to release the pipe.
3. Check the fitting and pipe end for damage. The fitting and pipe
should be free of damage, foreign objects and marks on the
outside diameter. If the pipe is damaged or marked, then cut and
use a new section of pipe.
DISCONNECT