SharkBite ® Installation Guide SB_InstallationInstructions_2020.
The Total Plumbing Solution Cut: Cut the pipe square removing rough edges and debris. Mark the pipe to the correct insertion depth. Push: Push pipe and fitting together up to the depth mark. Done. *Using the disconnect clip, fittings can be easily changed. Pipe Insertion Depth SharkBite Fitting Size Nominal Pipe Size Pipe OD Pipe Insertion Depth IN Pipe Insertion Depth MM 1/4 in. 1/4 in. CTS 3/8 in. 0.82 21 3/8 in. 3/8 in. CTS 1/2 in. 0.94 24 1/2 in. 1/2 in. CTS 5/8 in. 0.
The SharkBite Connection System ® The SharkBite® connection system is certified for potable water and radiant heating. SharkBite uses an advanced push-to-connect design that works in two stages. When the pipe is inserted into the fitting it passes the first stage through a release collar and then through a stainless steel grab ring. The grab ring has teeth that open out and grip onto the pipe. At the second stage the pipe is pushed through an o-ring protector which aligns the pipe.
Connecting a SharkBite Joint The following instructions must be followed to assemble the SharkBite Connection System. Preparation Select the correct size fitting and pipe for the job. Check that fittings and pipe are clean, in good condition and are free from damage and foreign objects. Also check that the pipe is round, and free from scratches, cuts, or gouges. Cut the pipe so that the ends are square. Ensure that there are no burrs or damage to the cut end.
Disconnecting a SharkBite Joint Disconnection of the joint can only occur by using either the SharkBite disconnect clip or the SharkBite disconnect tongs. By applying pressure to the release collar with the clip or the disconnect tongs, the grab ring teeth are splayed. This action releases the pipe, allowing it to be removed from the fitting. SB_InstallationInstructions_2020.indd 3 1. Place the SharkBite disconnect clip around the pipe with the non-branded face against the release collar.
Installation Requirements SharkBite® Burial SharkBite Silicone Burial Wrap SharkBite Universal fittings are suitable for burial in most applications; however care is required when using fittings in applications that require burial to ensure the correct installation practices are used and due care is given to any environmental factors that may have a detrimental effect on the life expectancy of the fittings and pipe. Make a SharkBite Universal connection ensuring pipe is inserted to proper depth.
Threaded Connectors 3. Teflon tape should be used with threaded SharkBite connectors to make a proper seal. The initial pipe and the new pipe must be clean and free from scratches and burrs. 4. The insertion depth must be marked on the pipe. Galvanized Tubing 5. The connection must be pressure tested and inspected by the installer to verify that there are no leaks. SharkBite Universal fittings should not be installed (threaded or push-to-connect) on galvanized tubing.
For more information, visit sharkbite.com Connect with us Reliance Worldwide Corporation 2300 Defoor Hills Rd NW, Atlanta, GA 30318 Phone: 1-877-700-4242 • Fax: 1-877-700-4280 rwc.com Reliance Worldwide Corporation (Canada) Inc. 74 Alex Avenue Vaughan, Ontario, L4L 5X1 Phone: 1-888-820-0120 Sales Inquiries: canadasales@rwc.com Orders: canadaorders@rwc.com Manufactured & Distributed by Reliance Worldwide Corporation®. 6 SB_InstallationInstructions_2020.
