Instruction Manual
BANDIT
5. Connect the 3.5" device to the power supply and the mainboard.
6. Screw the 5.25" bezel with 3.5" opening into the front panel and place it back
onto the case.
(5.25"bezelwith3.5"opening)
10. Installation of an add-on card
1. Presstheslotbezeloutofitsattachment(g.25).
fig. 25
2. Insert the add-on card into the mainboard’s respective slot and screw it to
thecase(g.26).
(Screwwithcoarsethread)
fig. 26
11. The pre-installed fans
1. The pre-installed case fans provide a 4-pin PSU connector and a 3-pin
mainboard plug each.
2.ConnectoneofbothplugstoeithertherespectivePSUor(tocontrolthefan
speedviathemainboard)thematchingmainboardconnector.
12. Installation of additional fans / optimized airflow
1. Placethefanagainsttherespectivebracketfromtheinside(e.g.theback
side/g.27).
fig. 27