Instruction Manual

BANDIT
3. Remove the mainboard and screw the stand-offs into the respective drillings
 ofthemountingpanel(g.3).
(Stand-offs)
fig. 3
4.PresstheI/Oshield(deliveredwiththemainboard)intotheI/Oshield
opening in the case’s back side.
5. Place the mainboard back onto the stand-offs and screw the mainboard to
 them(g.4).
 (Screwsformainboardmounting)
fig. 4
Note:
For more information on how to install the intended devices, refer to their
respective documents.
5. Installation of a mainboard
1. Open the case by loosening the thumb screws on the case’s back side and
 removingtheleftsidepanel.Laydownthecasesidewiseonanevensurface.
2. The mainboard’s mounting panel inside the case provides various drillings to
 xthestand-offs(g.1).
fig. 1
 Themainboardcontainsspecialscrewopenings(g.2).
fig. 2
Place the mainboard to the mounting panel. A stand-off must be screwed
into every drilling of the mounting panel visible through the mainboard’s
screw openings.