DEUTSCH FRANÇAIS ESPAÑOL ITALIANO NEDERLANDS PORTUGÛES POLSKI 88 Flexi-Drive S2S ENGLISH FLEXI-DRIVE S2S Manual
Content 2 2. Specifications 2 3. Manual 3 Flexi-Drive S2S ENGLISH 1.
Dear customer! Congratulations for purchasing one premium quality SHARKOON product. For a long life time and to take full advantage of this product we recommend that you read this manual completely. ENGLISH Have a good time with our product! SHARKOON Technologies GmbH 1. Features • • • • • • Fast modular SSD storage solution Memory size flexibly adaptable via SDHC memory cards (SLC/MLC) SATA interface (SATA I and II) 2.
3. Manual A B ENGLISH Note: If you intend to run an operating system on the Flexi-Drive S2S, we recommend to use SDHC memory cards with SLC memory and a read/write rate of at least 20 MB/s. C A B C – – – Jumper SATA data connector (7-pin) SATA power connector (15-pin) A – SATA I mode (1.
1. Open the case by removing the three screws with a suitable screw driver (fig. 1) and take off the case’s cover (fig. 2). ENGLISH fig. 1 fig. 2 2. Carefully remove the PCB from the case (fig. 3). fig.
3. Insert the desired number (max. 6) of SDHC cards into the PCB’s slots (fig. 4). ENGLISH fig. 4 Note: We recommend using cards of the same type and capacity. When using cards of different capacities only the smallest capacity will be used for all cards (e.g. 4GB + 8GB > 2x 4GB). To achieve the optimal data transfer rate insert cards in all 6 slots as the transfer rate rises according to the number of cards.
4. Place the PCB back into the case and close it (fig. 5). ENGLISH fig. 5 Warning: For potential loss of data, especially due to inappropriate handling, SHARKOON assumes no liability. All named products and descriptions are trademarks and/or registered trademarks of the respective manufacturers and are accepted as protected. As a continuing policy of product improvement at SHARKOON, the design and specifications are subject to change without prior notice. National product specifications may vary.
