Instruction Manual

NIGHTFALL
8. Installation of a 3.5" device
(1.Removethecase’sfrontpanelbygentlydraggingittowardsyou.)
2. Dismantle the 5.25" front bezel from the mounting bay in which you intend to install the
 drivebylooseningitsscrewsandpushingthebezeltotheinside(g.15).Removethequick
 fasteners(g.16).
 g.15                 g.16
 (Carefully take out an optionally presentmetal bezel coveringthe drive bay by using a
 gripper.)
3.Screwthemountinganglestothe3.5"devicefrombothsides(g.17).
 g.17
4.Slidethe3.5"devicewithattached mounting rails into thecase’sdrivebay(g.18)and
 screwittothedrivebayfrombothsides(g.19).
g.18                 g.19