Service manual

13VT-N100

13VT-N150

13VT-CN10

PICTURE: 16 2

Figure A.

The N-series SHARP TV/VCR COMBINATION have most of the analog setup adjustments eliminated. Coil and

variable resistor adjustments are now performed digitally by using the remote controller or set’s volume and

channel change function buttons.

Note: There are still a few analog adjustments in the L-series such as 120V adjust, focus, master screen

voltage and coils in the picture I/F detector circuit.

Follow the steps below, whenever service adjustment is required. See "Table-B" to determine, if service

adjustments are required.

3. Data number selection

Press the volume up or down button to adjust the

data number in the upper right hand side of the

screen.

1. Service mode

Berfore putting unit into the service mode, check that

customer adjustments are in the normal mode, use

the reset function in the video adjust menu to ensure

customer controls are in their proper (reset) position.

To enter the service mode

Plug in a television set, during push S2507 (CH-up).

When successfuly entered, the service mode will be

displayed as shown in Figure A.

To exit service mode

Turn off the power or unplug the set.

2. Adjustment Item selection

Once in the service mode, press the channel up or

channel down button on the remote controller or at

the set (Table-A). Select the item you wish to adjust.