User Manual

20
Tape Dubbing
Your TV/VCR COMBINATION can dub (copy) video material from another video device.
The connections are shown below. Begin recording on the TV and playback on the source VCR simultaneously.
Video Connection
1. At the Source VCR
• Insert a pre-recorded tape.
2. At the TV/VCR
• Insert a blank tape.
3. Choose Input Source
• Either pressing of INPUT or CHANNEL UP/DOWN (8/9) buttons on the TV/VCR set or Remote Control can be used to
select the channel.
(Pictures and sounds inputted through VIDEO IN/AUDIO IN can be played back on the INPUT channel.)
4. Play Back the Tape
• Press the PLAY button on the source video equipment.
5. Record (Copy) the Tape
• Press the REC button.
Note:
• When connecting video or audio equipment to the television, be sure that the power is turned off in order to prevent damage
to either the television or the equipment being connected.
• It is the intent of SHARP that this product be used in full compliance with the copyright law of the United States and that prior
permission be obtained from copyright owners whenever necessary.
• For detailed information on the connection and use of auxiliary equipment, refer to the instruction manuals of the equipment
being used.
• The connection cables can be obtained from your local video source.
POWER
POWER/
WAKE-UP
TIMER
REC
PROGRAM
TIMER
TAMPER
PROOF
CAMCORDER
FRONT
VIDEO EQUIPMENT
VCR TV GAMEDVD
FWDREV
VIDEO IN
FROM VIDEO SOURCE; To VIDEO OUT
AUDIO IN
To AUDIO OUT
20-22 13VT-CR10[E].pm65e 15/5/01, 7:25 pm20