User Manual

27
Troubleshooting
If the fault cannot be corrected by using this guide, remove the mains plug from the wall socket and
contact the dealer or supplier from whom it was purchased. Where this is not possible, please visit our
web-site at www.sharp.co.uk/support. Customers without internet access may telephone 08705
274277 during office hours (or [phone] if telephoning from Ireland).
Certain replacement parts and accessories may be obtained from our Main Parts Distributor, who can
be contacted on the following numbers:
Willow Vale Electronics Ltd.
0121 766 5414 and 0161 205 7531
In the unlikely event of this equipment requiring repair during the guarantee period, you will need to
provide proof of the date of purchase to the repairing company. Please keep your invoice or Receipt,
which is supplied at the time of purchasing.
Remote control does not work
Bars on screen
Picture distorted
Picture rolls vertically
No colour
Poor reception on some channels
Picture weak
Picture lines or streaks
Picture ghosting
Picture blurred
Sound OK, picture poor
Picture OK, sound poor
No picture or sound
Quick
Service
Check List
Problems
Possible Causes/Solutions
Tr y a new channel to check for possible
station trouble
The TV set not plugged in
Outlet power OFF
Power button of the TV set not on
Antenna not connected to terminal at the
back of the TV set
If outside antenna is used, check for broken
wires
Check for local interference
Tu rn off the TV set by pressing the Power button
on the TV set, then turn on again after a minute
Adjust COLOUR control
Check batteries in the Remote Control
Tr y fine tuning to correct
Check if the Brightness or Contrast setting in
Picture Adjustment might be set to the minus
side.
Increase the volume
This TV set is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the TV set and plug it in again after a few minutes.