User`s manual

INSTALLATIONS
6 MB700 User’s Manual
Installing the CPU
MB700 supports a Socket 370 processor socket for Intel Celeron/
Coppermine processors.
The Socket 370 processor socket comes with a lever to secure the
processor. Raise this lever to about a 90° angle to allow the insertion of
the processor. Place the processor into the socket by making sure the
notch on the corner of the CPU corresponds with the notch on the inside
of the socket. Once the processor has slide into the socket, return the lever
to the lock position. After you have installed the processor into the
socket, check if the jumpers for the CPU type and speed are correct.
NOTE:
Ensure that the CPU heat sink and the CPU top surface are in
total contact to avoid
CPU overheating problem that would
cause your system to hang or be unstable.
MicroPCI Daughter Card Installation
MB700 is integrated with one MicroPCI socket that uses SO-DIMM
144-pin connectors. These sockets can accommodate the VGA, Ethernet
or SCSI MicroPCI daughter cards.
To insert a MicroPCI daughter card, position it at about 30° (Figure 1)
to the PCB and gently push it into the MicroPCI socket. Once inserted,
slowly press the card towards the PCB until it locks on both sides to the
clips of the connector (Figure 2). Screw the card to the PCB to secure the
installation.
Figure 2.
Figure 1.
Figure 1. Figure 2.