User`s manual

INSTALLATIONS
MB700 User’s Manual 29
Turbo LED Connector: Pins 8 and 18
There is no turbo/deturbo function on the CPU card. The
Turbo LED on the control panel will always be On when
attached to this connector.
Pin # Signal Name
8 5V
18 Ground
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without
turning the main power switch off and then on again.
Orientation is not required when making a connection to this
header.
Hard Disk Drive LED Connector: Pins 10 and 20
This connector connects to the hard drive activity LED on
control panel. This LED will flash when the HDD is being
accessed.
Pin # Signal Name
10 Ground
20 5V
J35: Wake on LAN Connector
J35 is a 3-pin header for the Wake on LAN function on the motherboard.
The table below shows the pin out assignments of this connector. Wake
on LAN will function properly only with an ATX power supply with
5VSB that has 1A.
Pin # Signal Name
1 +5VSB
2 Ground
1 2 3
3 Wake on LAN