User`s manual

BIOS SETUP
MB700 User’s Manual 49
Integrated Peripherals
This option sets your hard disk configuration, mode and port.
ROM PCI/ISA BIOS
INTEGRATED PERIPHERALSP
AWARD SOFTWARE INC.
IDE HDD Block Mode : Enabled Onboard FDC Controller : Enabled
IDE Primary Master PIO : Auto
IDE Primary Slave PIO : Auto Onboard Serial Port 1 : 3F8/IRQ4
IDE Secondary Master PIO : Auto Onboard Serial Port 2 : 2F8/IRQ3
IDE Secondary Slave PIO : Auto UART Mode Select : Normal
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA : Auto
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA : Auto Onboard Serial Port 3 : Disabled
On-Chip Primary PCI IDE : Enabled
On-Chip Secondary PCI IDE : Enabled Onboard Serial Port 4 : Disabled
USB Keyboard Support : Disabled
Init Display First : AGP
KBC input clock : 8 MHz
PWRON After PWR-Fail : Off Digital I/O Address : 260h
ESC : Quit á â ß : Select Item
Onboard Parallel Port : 378/IRQ7 F1 : Help PU/PD/+/- : Modify
Parallel Port Mode : SPP F5 : Old Values (Shift) F2 : Color
F6 : Load BIOS Defaults
F7 : Load Setup Defaults
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
IDE Primary/Secondary Master/Slave PIO
These fields allow your system hard disk controller to work faster. Rather
than have the BIOS issue a series of commands that transfer to or from the
disk drive, PIO (Programmed Input/Output) allows the BIOS to
communicate with the controller and CPU directly.
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select the
best available mode.
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to
33Mb/sec with the Ultra DMA/33 feature. The options are Auto and
Disabled.