User`s manual

BIOS SETUP
50 MB700 User’s Manual
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with
support for two IDE channels. Select Enabled to activate each channel.
USB Keyboard Support
Select Enabled if your system is using a USB keyboard.
Init Display First
This field allows the system to initialize first the VGA card/hardware
when system is turned on.
KBC input clock
The default setting of the KBC input clock is 8 MHz.
PWRON After PWR-Fail
Enabling this field causes the system to power on by itself when power is
restored, in case the system shuts down due to power failure.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install an
add-in FDC or the system has no floppy drive, select Disabled in this
field. This option allows you to select the onboard FDD port.
Onboard Serial/Parallel Port
These fields allow you to select the onboard serial and parallel ports and
their addresses. The default values for these ports are:
Serial Port 1: 3F8/IRQ4, Serial Port 2: 2F8/IRQ3
Serial Port 3: Disabled, Serial Port 4: Disabled
Parallel Port: 378H/IRQ7
UART Mode Select
This field determines the UART mode in your computer. The settings are
Normal, IrDA and ASKIR. The default value is Normal.
Parallel Port Mode
This field allows you to determine parallel port mode. Settings include
SPP (Standard Printer Port), EPP (Enhanced Parallel Port), and ECP
(Extended Capabilities Port.)
Digital I/O Address
The default value of the digital I/O address is 260h.