User`s manual

LAN DRIVERS INSTALLATION
56 MB700 User’s Manual
Installing the Drivers for Windows NT 4.0
Once you are in the Windows NT 4.0 environment, follow the procedures
below to install the VGA drivers that come with your board.
1. Click the Start button, then go to Settings and click on Control
Panel.
2. Click on the Display icon to start the Display Properties window.
3. Click on the Settings tab, and then click on Display Type.
4. In the Change Display Type window, click on Change Adapter
Type. This will bring up the Select Device window.
5. In the Change Display window, click on Have Disk. Enter the
directory where the Windows NT driver files are located as
d:\vga\ct69000\winnt40 (assuming D: is the CD-ROM drive.)
Then select OK, or press ENTER.
6. Select Chips Video Accelerator from the display list provided, then
click OK or press ENTER.
7. You will then see a warning panel about Third Party Drivers. Click
on Yes to finish the installation.
8. Once the installation is complete, the system must be shut down and
restarted for the new drivers to take effect.
9. When the system has restarted, the default graphics mode (usually
640x480x256color) has been automatically selected. Click the Start
button, and then go to Settings and click on Control Panel. Click on
the Display icon to start the Display Properties window. Click on
the Settings tab. A new screen setting can be selected using either of
the following methods:
A. Use the slide-bar in the Desktop Area to select new setting.
B. Click on List All Modes. From the list provided, select a
new setting, then click OK or press ENTER.
C. Click on Test to test the newly selected graphics mode.
Follow the instructions given on screen. A test screen
should appear, followed by the Testing Mode window.
Click on Yes to continue. Click on Apply to switch to the
new graphics mode. Graphics modes are changed
dynamically on NT 4.0, so you do not need to shut down and
restart for the new screen settings to work.