User Manual

E 19
• AUTO
The AUTO mode screen will appear.
(i) Pressing
MENU/PRESET
changes the
screen as shown below.
(ii) Pressing
/
again and Auto Channel Tuning
is started.
(Please see page
16
for details on Auto Channel Tuning.)
• FINE (MANUAL)
(i) Each time
/ is pressed, the frequency changes
to allow fine tuning and the colour of channel number changes to
yellow.
(ii) Press
/ for more than 4 seconds, the “Manual
Channel Tuning” will start. If a signal is found, the Manual
Channel Tuning will stop searching.
•
Channel number in Red : Manual Channel Tuning is
performing.
•
Channel number in Green : Manual Channel Tuning is stop.
Repeat (ii) above to continue Manual
Channel Tuning.
• Switching COLOUR system:
Set the system to “AUTO” for normal TV reception. The AUTO mode automatically detects the receiving
signal system and changes the reception system of the TV set. When the picture is not stable, switching
to an appropriate system may improve the picture quality.
• In a weak reception area, or under bad reception conditions, you can change the frequency by fine tuning.
• When using FINE, the channel number changes from green to yellow.
• To return the channel to its original frequency setting, follow the manual channel tuning procedure.
See
17
.
• Channel setting menu cannot be selected during COMPONENT mode.
Channel setting (continued)
Settings and adjustments
AUTO PAL SECAM
N443
N358
MANUAL
NORMAL
SCREEN
AUTO
AUTO(B/G)
VHF 7
224.25MH z
6 Press
MENU
until normal
screen appears.
• When you select AV1, AV2 for the
channel position, the CH-SETTING
menu changes as shown on the
right and the colour mode changes
in the following order:
CH-SETTING
POSITION AV1
COLOUR AUTO
MENU
:ADJUST :RETURN
:SELECT
CH