Service manual

1 – 10
UX-340L/UX-345L UX-330L
UX-340L (TCADZ2890XHZZ)
UX-345L (TCADZ2893XHZZ)
UX-330L (TCADZ2964XHZZ)
[6]Quick Setup Guide
Be sure to perform each step in the
order indicated.
Note: For detailed instructions, refer to
the indicated pages of the operation
manual.
1.
Open the operation panel and then pull the green release
forward to open the print compartment cover.
2.
Remove the roll of imaging film from its
packaging. (Note: Do not yet remove the band
that holds the rolls together.)
3.
Insert the large gear into the green end of the
empty spool. Insert the remaining three gears
into the ends of the spools. (Make sure the
protrusions on the gears fit into the slots in the
spool ends.)
IMPORTANT: Do NOT discard green gears. They
are not included with replacement imaging film.
4. Insert the large gear into the large holder
on the imaging film cartridge, and then
insert the small gear on the other end of
the spool into its holder.
5. Cut the band that holds the two spools
together. Unroll the film slightly and
insert the small gears into their holders.
6.
Turn the cartridge over and insert it
into the print compartment.
7.
Rotate the large gear toward you until
the film is taut.
8.
Close the print compartment cover (press down on both sides to make
sure it clicks into place), and then close the operation panel.
1
Connect the handset and place it
on the handset rest.
2
Plug the power cord into a 120
V, 60 Hz, grounded (3-prong) AC
outlet.
3
Connect the telephone line
cord to the TEL. LINE jack
and a wall telephone jack.
TEL.
SET
TEL.
LINE
Large gear
4
Attach the supports.
Note: If the
support doesn’t
go in, turn it over.
5
Load the imaging film.
Note: To connect an answering machine
to the fax. To connect an extension
phone.
Pull the spools
apart slightly to
allow the gears to
fit in.