Service manual

1 – 1
UX-340L/UX-345L
UX-330L
CHAPTER 1. GENERAL DESCRIPTION
[1] Specifications
Automatic dialing: Rapid Key Dialing: 4 numbers
(UX-340) Speed Dialing: 40 numbers
Automatic dialing: Rapid Key Dialing: 7 numbers
(UX-345) Speed Dialing: 80 numbers
Imaging film: Initial starter roll (included with fax
machine): 32 ft. (10 m)(approx. 30
letter-size pages)
Replacement roll:
UX-3CR 98 ft. (30 m) roll (two rolls in
package, one roll yields approx. 100
letter-size pages)
Memory size* : 476 KB (approx. 27 average pages)
Modem speed: 9600 bps with automatic fallback to
lower speed
Transmission time* : Approx. 15 seconds
Resolution: Horizontal:
203 pels/inch (8 dots/mm)
Vertical:
Standard: 98 lines/inch
(3.85 lines/mm)
Fine/Halftone: 196 lines/inch
(7.7 lines/mm)
Super fine: 391 lines/inch
(15.4 lines/mm)
Automatic document feeder: 10 sheets max. (20 lb paper)
Recording system: Thermal transfer recording
Halftone (grayscale): 64 levels
Display: 16-digit LCD display
Paper tray capacity: Letter: 60 sheets
(16-to 20-lb. paper) Legal: 30 sheets
Compression scheme: MH, MR, Sharp(H2)
Applicable telephone line: Public switched telephone network
Compatibility: ITU-T (CCITT) G3 mode
Input document size: Automatic feeding:
Width  5.8 to 8.5"
(148 to 216 mm)
Length  5.5 to 11"
(140 to 279 mm)
Manual feeding:
Width  5.8 to 8.5"
(148 to 216 mm)
Length  5.5 to 23.6"
(140 to 600 mm)
Effective scanning width: 8.3" (210 mm) max.
Effective printing width: 8.3" (210 mm) max.
Contrast control: Automatic/Dark selectable
Reception modes: TEL/FAX/A.M. (Note: A.M. mode is for
connecting an answering machine)
Copy function: Single/Multi/Sort (99 copies/page)
Telephone function: Ye s
(cannot be used if power fails)
Power requirements: 120 V AC, 60 Hz
Operating temperature: 41 to 95°F (5 to 35°C)
Humidity: Maximum: 85 %
Power consumption: Stand-by: 4.2 W
Maximum: 100 W
Dimensions: Width: 13.5" (343 mm)
Depth: 10.1" (256 mm)
Height: 7.2" (182 mm)
Weight: Approx. 7.3 lbs. (3.3 kg)
* Based on ITU-T (CCITT) Test Chart #1 at standard resolution in Sharp
special mode, excluding time for protocol signals (i.e., ITU-T phase C
time only).
Note: The facsimile machine is Year 2000 compliant.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for procduct
improvement without prior notice. The performance specifications figures indicated are nominal values of production units. There may be some
deviation from these values in individual units.