User`s guide

36 Options Guide RX100 S4
Upgrading to hot-plug variant Upgrade kit hot-plug variant
Figure 21: Leading the cables
Ê Thread the I
2
C cable and the LED cable through the separating plate (see
arrow).
Ê Connect the I
2
C cable to the connector CN17 on the system board.
Ê Connect the LED cable to the connector CN11 on the system board.
Ê Install the new hot-plug hard disks as described in the Operating Manual
RX100 S4.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter “Completion” on page 37 et seq. .