Technical data

13
INSTALLATION
1
1
Make sure the paper release lever is pushed back. The paper will be
clamped by the paper feed roller inside the copier.
When placing special paper or several sheets of paper or when
making two-sided copies, the paper may not be clamped inside
the machine even if the paper release lever is pushed back. In
this case, repeat the paper release lever operation several times
to make sure that the paper is clamped.
Loading copy paper
Paper guide
Side to be printed
Paper support
4
Power to machine
Ensure that the power switch of the machine is in the OFF position. Insert
the attached power cord into the power cord socket at the rear of the
machine.
1
2
If you use the machine in a country other than the country where the
copier was purchased, you will need to make sure that your local power
supply is compatible with your model. If you plug the machine into an
incompatible power supply, irreparable damage to the machine will
result.
Plug the other end of the power cord into the nearest outlet.
Only insert the power cord into a properly grounded wall socket.
Do not use extension cord or multi-way power distribution boards.
SUK 01 INSTALLATION LEO.p65 30/03/00, 17:4513