Technical data

INITIAL SETTINGS
49
6
The date and time that appear in the display are printed at the top of each page
you transmit. Set the date and time by pressing the keys on the operation
panel as shown below. To correct a mistake, press the STOP key to move the
cursor back to the mistake, and then enter the correct number.
Note: The machine supports the year 2000. To program such a date, enter the
last two digits; for example, the year 2000 is programmed by entering
“00”.
Use the following procedure to set the date and time:
Step Press these keys Comments
1 “ENTRY MODE” will
appear in the display.
2 “ENTER YEAR” will appear
in the display.
3 Enter the last two digits of
the year. “ENTER MONTH”
will appear in the
(example: 2000) display.
4 Enter the month (2 digits:
“01” for January, “02” for
February, “12” for
December, etc.). “ENTER
DATE” will appear in the
(example: July) display.
5 Enter the day of the month
(“01” to “31”). “PRESS
ENTER KEY” will appear
(example: the fifth) in the display.
6 “ENTER TIME” will appear
in the display.
7 Enter the hour (2 digits:
“01” to “12”).
8 Enter the minute (2 digits:
“00” to “59”).
9 The clock starts when you
press this button.
“STORED” will appear in
the display.
10 Press the STOP key twice
to exit.
Setting the Date and Time
Fax Setup
DEF
ABC
STOP
STOP
ENTER
FUNCTION
DEF
JKL
ENTER
ABC
PQRS
SUK 06 INITIAL LEO.p65 30/03/00, 17:0049