Technical data

INITIAL SETTINGS

If Quiet Detect Time is not working properly...

With some answering machines, there is simply no Quiet Detect Time that will

allow both reception of faxes and uninterrupted voice messages. Even in this

case, however, you can set up the machine to receive both phone and fax

messages from callers on touch-tone lines. Follow this procedure:

1. Set the Quiet Detect Time to 00.

2. Using the Remote Reception Number (factory set to 5) to start fax reception,

change your answering machine message to include the following

information. “If you want to send a fax press 5 and then press the ( ) key

twice, after you hear the fax tone press your FAX START key”.

There may be times when the tape on your answering machine becomes full,

or when the answering machine itself malfunctions. It is still possible to receive

faxes even under these conditions, however, by turning on the Auto Receive

function. The machine will automatically answer all calls after five rings. To use

this function, follow the procedure below.

Factory setting: 2 (OFF)

Step Press these keys Comments

1 “A.M. MODE” will appear

in the display.

2 “SELECT AUTO

RECEIVE” will appear in

the display.

3 Press 1 to turn Auto

Receive on, or 2 to turn it

off.

4 Press the STOP key twice

to exit.

Note: If you are using Auto Receive, make sure that your answering machine

is set to answer on four rings or less. Otherwise, the machine will take

over all calls, preventing callers from leaving voice messages.

Answering Machine Backup

FUNCTION

TUV

ABC

STOP

ABC

Using the Machine with an Answering Machine

SUK 06 INITIAL LEO.p65 30/03/00, 17:0164