Service manual

R-1512

R-1511

8. Screw the oven lamp off from the lamp socket.

9. Now, the oven lamp is free.

10.Pull the wire leads from the oven lamp socket by pushing

the terminal hole of the oven lamp socket with the small

flat type screw driver.

11.Now, the oven lamp socket is free.

1. Disconnect the power supply cord.

2. Open the door and block it open.

3. Remove three (3) screws holding the hood exhaust

louver to oven cavity front face plate.

4. Remove the hood exhaust louver from the oven by

pushing the right and left tabs of the hood exhaust louver.

(Refer to procedure of “HOOD EXHAUST LOUVER

REMOVAL”)

5. Remove one (1) screw holding the control panel to the

oven cavity front face plate.

6. Release the control panel from the oven cavity front face

plate by lifting it up and tilting top edge back.

7. Turn the lamp socket and release it from the magnetron

duct.

OVEN LAMP SOCKET REMOVAL

Oven lamp

socket

Terminal

Wire lead

Terminal hole

Flat type small

screw driver

5. Disconnect only the connector CN-F from the control

unit. It is not necessary to disconnect other connectors

or wire leads from the control unit.

6. Release the oven lamp socket from the magnteron duct

by turning the socket counterclockwise.

7. Remove the oven lamp from the socket by turning the

oven lamp.

8. Now the oven lamp is free.