Service manual
5
R-1512
R-1511
NOTE: Some one-touch cooking features such as "MINUTE
PLUS" are disabled after three minutes when the
oven is not used. These features are automatically
enabled when the door is opened and closed or
STOP/CLEAR button is pressed.
CONTROL PANEL
1000
WATTS
KEEP WARM
PLUS
REHEAT
POWER
LEVEL
TIMER
CLOCK
BAKED
POTATOES
POPCORN
FRESH
VEGETABLES
CUSTOM
HELP
HOT
WATER
FRESH ROLLS/
MUFFINS
FROZEN ROLLS/
MUFFINS
BEVERAGE
LIGHT
HI/
LO
FAN
HI/ LO
STOP
CLEAR
START
MINUTE PLUS
INSTANT SENSOR
REHEAT
1 GROUND MEAT
2 RICE
3 FISH/SEAFOOD
4 FROZEN ENTREES
5 CHICKEN BREAST
6 FROZEN VEGETABLES
1 GROUND MEAT
2 STEAKS/CHOPS
3 BONELESS POULTRY
4 BONE-IN POULTRY
06789
51234
COOK SENSOR LBS KG DEF HELP
SENSOR
COOK
CENTER
DEFROST
CENTER
OPERATION
DESCRIPTION OF OPERATING SEQUENCE
The following is a description of component functions during
oven operation.
OFF CONDITION
Closing the door activates the door sensing switch and
primary interlock switch. (In this condition, the monitor
switch contacts are opened.)
When oven is plugged in, 120 volts A.C. is supplied to the
control unit. (Figure O-1).
1. The display will show "SHARP SIMPLY THE BEST
PRESS CLEAR AND PRESS CLOCK".
To set any program or set the clock, you must first
touch the STOP/CLEAR button. The display will clear,
and " : " will appear .
POWER LEVEL P-0 TO P-90 COOKING
When Variable Cooking Power is programmed, the 120
volts A.C. is supplied to the power transformer intermittently
through the contacts of relay (RY2) which is operated by the
control unit within an interval second time base.
Microwave power operation is as follows:
VARI-MODE ON TIME OFF TIME
HIGH (100% power) 32 sec. 0 sec.
P-90 (approx. 90% power) 30 sec. 2 sec.
P-80 (approx. 80% power) 26 sec. 6 sec.
P-70 (approx. 70% power) 24 sec. 8 sec.
P-60 (approx. 60% power) 22 sec. 10 sec.
P-50 (approx. 50% power) 18 sec. 14 sec.
P-40 (approx. 40% power) 16 sec. 16 sec.
P-30 (approx. 30% power) 12 sec. 20 sec.
P-20 (approx. 20% power) 8 sec. 24 sec.
P-10 (approx. 10% power) 6 sec. 26 sec.
P-0 (0% power) 0 sec. 32 sec.
Note: The ON/OFF time ratio does not correspond with
the percentage of microwave power, because
approx. 3 seconds are needed for heating of the
magnetron filament.