Operation Manual, Quick Start Guide

BEFORE USING THE MACHINE
11
(1) Finisher (large stacker)*
This staples paper. A punch module can also be installed
to punch holes in output paper.
(2) Saddle Stitch Finisher (large stacker)*
This staples and folds paper. A punch module can also
be installed to punch holes in output paper.
You can also perform stapling manually.
(3) Punch module
This is used to punch holes in output.
(4) Inserter*
Covers and insertion sheets to be inserted into printed
sheets can be loaded.
Using the manual finishing function, you can directly feed
paper into the finisher (large stacker) or saddle stitch
finisher (large stacker) to staple, punch or fold the paper.
(5) Bypass tray*
Use this tray to feed paper manually.
When loading paper larger than A4R or 8-1/2" × 11"R,
pull out the extension guide.
► LOADING PAPER IN OTHER TRAYS (page 21)
(6) Finisher*
This staples paper. A punch module can also be installed
to punch holes in output paper.
You can also perform stapling manually.
(7) Saddle Stitch Finisher*
This staples paper. A punch module can also be installed
to punch holes in output paper.
(8) Trimming module*
This trims the excess of saddle-stitched output.
(9) Folding unit*
This folds and outputs paper.
(10) Curl correction unit*
This punches and outputs paper.
(11) Paper pass unit*
This feeds paper to the machine.
(12) Large capacity trays*
Store paper in this tray. Store paper in this tray. Up to
2500 sheets can be stored in each tray.
LOADING PAPER IN OTHER TRAYS (page 21)
* Peripheral device. For more information, see the User's Manual.
(8)(7)(6) (9) (10) (11) (12)
(4)(2)(1) (5)(3)