Unit installation

Select a position where the condensing water can be easily drained out, and the place

is easily connected to outdoor unit.

4.Select the place where is strong enough to withstand the full weight and vibration

the unit. And will not increase the noise.

Make sure that the indoor unit installation should accord with installation dimension

diagram requirements.

Select a location where the children can not reach.

1.The unit installation work must be done by qualified personnel according to the local

rules and this manual.

2.Before installation, please contact SHARP authorized service

center, if unit is

not installed by the SHARP authorized service center, the malfunction may not be

solved, due to discommodious contacts.

3.W

hen removing the unit to other places, please contact SHARP authorized service

center.

Notices for installation

Important Notices

Basic Requirements For Installation Position

Install in the following place may cause malfunction. If it is unavoidable, contact SHARP

authorized service center please:

Place where strong heat sources, vapors, flammable gas or volatile object are emitted.

Place where high-frequency waves are generated by radio equipment, welders and

medical equipment.

Place where a lot of salinities such as coast exists.

Place where the oil (machine oil) is contained in the air.

Place where a sulfured gas such as the hot spring zones is generated.

Other place with special circumstances.

Indoor Unit Installation Position Selection

The air inlet and outlet vent should be far from the obstruction, make sure that the air

can be blown through the whole room.

Be sure to leave enough space to allow access for routine maintenance. The height of the

installed location should be 250cm or more from the floor.

Select a place about 1m or more away from TVset or any other electric appliances.

Select a place where the filter can be easily taken out.

1