Specifications

MX-3610N SIMULATION 5 – 33
26
26-1
Purpose
Setting
Function (Purpose)
Used to set Yes/No of installation of the
right paper exit tray.
Section
Paper exit
Operation/Procedure
1) Enter the set value with 10-key.
2) Press [OK] key. (The set value is saved.)
This setting is required to use the right paper exit tray unit.
26-2
Purpose
Setting
Function (Purpose)
Used to set the paper size of the large
capacity tray (LCC). (When the paper size
is changed, this simulation must be exe-
cuted to change the paper size in software.)
Section
Paper feed
Operation/Procedure
Select a paper size and a weight system to be changed.
26-3
Purpose
Setting
Function (Purpose)
Used to set the specifications of the auditor.
(Setting must be made according to the
auditor use conditions.)
Section
Auditor
Operation/Procedure
Select an item to be set with the touch panel.
(*1) Displayed only when EQUITRAC.
(*2) Details of the vendor mode
Item/Display Content
A 0 YES Paper exit tray: YES
1 NO Paper exit tray: NO
Item Setting value Content
LCC 0 8.5 x 11
1A4
2B5
G/LBS SET 0 GRAM
1LBS
Destination
Setting value
LCC G/LBS SET
U.S.A 8.5 x 11 LBS
CANADA 8.5 x 11 LBS
INCH 8.5 x 11 LBS
JAPAN A4 GRAM
AB_B A4 GRAM
EUROPE A4 GRAM
U.K. A4 GRAM
AUS. A4 GRAM
AB_A A4 GRAM
CHINA A4 GRAM
Item/Display Content
Default
value
BUILT-IN
AUDITOR
P10 Built-in auditor mode
(standard mode) operation.
P10
OUTSIDE
AUDITOR
NONE No external connection
vendor is used.
NONE
P VENDOR1 Coin vendor mode
(Only the copy mode can
be controlled.)
P VENDOR3 Vendor mode in which
signals for the intercard
connected to the PCU are
used for communication in
parallel I/F.
P OTHER Mode for an external
auditor connected to the
SCU.
VENDOR-EX
(*1)
Vendor I/F for EQUITRAC
VENDOR-EX
(MULTI) (*1)
VENDOR-EX + Multi job
cueing Enable mode
S_VENDOR Serial vendor mode
DOC ADJ ON Support for the auditor in
document filing print
OFF
OFF No support for the auditor in
document filing print
PF ADJ ON Continuous printing is
performed in the duplex
print mode.
If the remaining money
expires during continuous
printing, the sheets in the
machine are discharged
without being printed on the
back surfaces.
OFF
OFF Continuous printing is not
performed in the duplex
print mode. (The remaining
amount is checked for
printing every surface in all
the printing process.)
If the remaining money
expires during printing, the
sheet is discharged without
printing on the back
surface.
VENDOR
MODE (*2)
MODE1 Vendor mode 1 MODE
3
MODE2 Vendor mode 2
MODE3 Vendor mode 3
COUNTUP
TIMING
FUSER_IN Mode in which the detection
timing of the paper lead
edge by the sensor after the
paper passes the fusing
section is used as the
money charging timing.
EXIT_
OUT
FUSER_OUT Mode in which the detection
timing of the paper rear
edge by the sensor after the
paper passes the fusing
section is used as the
money charging timing.
EXIT_OUT Mode in which the detection
timing of the paper rear
edge by the paper exit
sensor of the right paper
exit tray or of the after
process unit is used as the
money charging timing.