Specifications

23
: Signal sent confirmation LED
: IFEEL mode indicator
FAN
: Fan Speed indicator
: Temperature display indicator
4.3. How to insert the batteries
Use two new alkaline type batteries with AAA 1,5V.
(1) Slide down the cover of the battery compartment.
Remove the used batteries and insert new ones correctly.
(2) Reattach the cover by sliding it back into its position.
Notes
♦ Do not use old batteries or different type batteries. Such a use may cause remote control
wrong functioning.
♦ If you do not use the remote control more than two weeks, remove the batteries. Damages
may be caused by possible leakages.
♦ Replace batteries when no "beep" is received from the indoor unit or if the transmission
indicator on the remote controller fails to light.
4.4. How to use the remote control to operate the unit
● SWITCHING THE UNIT ON AND OFF
Press the
button to switch the unit on or off.
● SETTING THE OPERATING MODE
By pressing the Mode button several times it is possible to change the unit operating mode. The selected operating mode
symbol appears on the display.
→ → → →
: automatic mode
: cooling mode
: dehumidification mode
: fan only mode
: heating mode
When the automatic programme AUTO is selected, the unit may operate in COOLING or HEATING mode depending on the
temperature difference in place between the ambient temperature and the temperature selected on the remote control.
When the cooling mode
is selected, the unit operates with a free temperature setting, lowering the ambient temperature.
When the dehumidification mode
is selected, the unit operates with a free temperature setting, progressively lowering the
ambient temperature and humidity. When the dehumidification mode is in operation, the FAN button cannot be used. When
the heating mode
is selected, the unit operates with a free temperature setting, raising the ambient temperature. When
the fan mode
is selected, the unit operates without temperature settings, simply blowing air through the environment.
IMPORTANT!
♦ The unit fan stops when the set temperature is reached and is then automatically reactivated at minimum
speed to prevent air stratification phenomena in the vicinity of the appliance.
♦ When the COOLING,
DEHUMIDIFICATION mode is selected, the fan may not start up straight away because the
ANTI-HEATING mode is present. When the HEATING mode is selected, the fan may not start up straight away
because the ANTI-COOLING mode is present.
● SETTING THE LOUVERS
In order to obtain optimal air distribution, adjust the motorised louvers, making sure that the air flow is not directly pointed at
anyone. For the motorised louvers, proceed as follows:
1) Press the button
to set swing up and down angle, which circularly changes as below: