Owner manual

TOP
TOP
Printing
Index
Introduction
Scanning
Using the Sharp
Control Panel
Table of Contents
Working with
Imaging Files
53
Below is a description of each tool and some suggested uses:
• Rotate Left/Rotate Right
These commands allow you to rotate an image 90 degrees left or
right.
• Flip Horizontally
This flips an image horizontally, as if it were on a sheet of
transparent film and you flipped it over to view it from the other side.
• Flip Vertically
The effect on the image is the same as the Flip Horizontally
command, except that the image is flipped vertically.
• Straighten
The straightening tool is especially useful on images that have
become slightly skewed, or look a bit off after scanning.
• Invert
This feature changes dark areas to light, and vice versa. In effect, it
creates a “photographic negative” of the image.
03-2.fm Page 53 Monday, February 5, 2001 4:33 PM