Service manual

AL-1651CS DISASSEMBLY AND ASSEMBLY 8 - 15
2) Disconnect the connector.
3) Remove two screws, and remove the scanner motor.
4) Remove two screws and one harness, and remove the main
motor.
5) Remove two screws and one connector, and remove the exhaust
fan motor.
Note: Be careful of the installing directions of the fan.
Attach it so that the blowing direction faces outside.
C. Assembly procedure
For assembly, reverse the disassembly procedure.
8. Power section
A. List
B. Disassembly procedure
1) Disconnect each connector.
2) Remove the screw, and remove the earth line.
3) Remove two screws, and remove the power PWB unit.
C. Assembly procedure
For assembly, reverse the disassembly procedure.
9. Duplex motor section (RSPF model only)
A. Remove the rear cabinet.
1) Remove four screws.
2) Remove the rear cabinet.
B. Remove the main PWB.
1) Disconnect the connector.
2) Remove the two screws, and remove the NIC PWB.
1)
3)
2)
1)
2)
3)
1)
2)
3)
Blowing direction
No. Part name Ref.
1 Power PWB
1)
1)
1)
1)
2)
3)
4)
4)
5)
1)
2)
2)
3)
1)