Service manual

ManualsBrandsSharp ManualsAll in One PrinterAL-1651CS

AL-1651CS TEST COMMAND, TROUBLE CODES 10 - 11

26 03 Second cassette setting

(2ND TRAY)

[Function]

When this test command is executed, the current set second cassette is displayed. Enter the code

number corresponding to the desired second cassette and press [ENTER/START] key to save the

setting.

[Operation]

The operation is similar to test command 21-01.

04 Main unit duplex setting

(DPLX)

[Function]

When this test command is executed, the current set duplex is displayed. Enter the code number cor-

responding to the desired duplex and press [ENTER/START] key to save the setting.

[Operation]

The operation is similar to test command 21-01.

06 Destination setting

(DESTINATION)

[Function]

When this test command is executed, the current set destination is displayed. Enter the code number

corresponding to the desired destination and press [ENTER/START] key to save the setting.

∗ For Japan AB series, there is no schedule for production.

[Operation]

The operation is similar to test command 21-01.

07 Machine conditions check

(CPM)

[Function]

When this test command is executed, the current machine setting is displayed.

[Operation]

20 Rear edge void setting (END

EDGE)

[Function]

When this test command is executed, the current set rear edge void is displayed. Enter the code num-

ber corresponding to the desired rear edge void and press [ENTER/START] key to save the setting.

[Operation]

The operation is similar to test command 21-01.

Main

code

Sub

code

Contents Details of function/operation

Code number Second cassette Display item

0 Second cassette NO OFF

1 Second cassette YES ON

Code number Duplex Display item

0 Duplex NO OFF

1 Duplex YES ON

Code number Destination Display item

0 Inch series INCH

1 EX Japan AB series AB

2 Japan AB series –

3 China (EX Japan AB series + China paper support) CHINA

CPM Coy quantity Remark

10 CPM 10

12 CPM 12

13 CPM 13

14 CPM 14

15 CPM 15

16 CPM 16

1) The machine setting is displayed.

26-07 CPM

10 CPM

Code number Setting Display item Remark

0 Rear edge void NO OFF

1 Rear edge void YES ON Default