Specifications
Table Of Contents
- Introduction
- How to Use the Online Manual
- Contents
- Basic Printing
- Opening the Printer Driver From the "Start" Button
- Printer Driver Settings
- Printing Multiple Pages on One Page
- Fitting the Printed Image to the Paper
- Two-sided Printing
- Rotating the Print Image 180 Degrees
- Printing a Watermark
- Outline of the Print Status Window
- Scanning Overview
- Scanning from a TWAIN-Compliant Application
- Scanning from a WIA-Compliant Application (Windows XP)
- Scanning from the "Scanner and Camera Wizard" (Windows XP)
- Outline of Button Manager
- Button Manager Settings
- Troubleshooting
- If a Notice Page is printed
- Printer Driver Features
- About the Web Page
- Configuration via the Web Page
- Index
3
TROUBLESHOOTING
30
CONTENTS INDEX
Troubleshooting
(part 2)
Problem Cause and solution Page
The machine does not print.
The printer driver has not been installed properly.
→ Follow these steps to check and see if the printer driver is installed.
1 Click the "start" button, click "Control Panel", click "Printers and Other Hardware",
and then click "Printers and Faxes".
(On Windows 95/98/Me/NT 4.0/2000, click the "Start" button, select "Settings" and
then click "Printers".)
2 Does the "SHARP AL-XXXXCS" printer driver icon appear?
3 If the icon is shown but you still cannot print, the printer driver may not have been
installed correctly.
In this case, delete "SHARP AL-1500/1600CS Series Printer (or MFP) Driver" and
then reinstall it.
Operation
Manual
A copy job is in progress.
→ Wait until the copy job is finished.
-
The size of paper loaded in the tray is different from the paper size setting in the
machine.
→ Make sure that the size of paper loaded in the tray and the machine's paper size
setting agree.
Operation
Manual
The specified size of paper has not been loaded.
→ Load the specified size of paper in the paper tray.
Operation
Manual
The "FORCED OUTPUT" setting is set to "OFF".
→ When "FORCED OUTPUT" is set to "OFF" and there is no paper in the machine that
is the same size as the print image, load paper in the bypass tray as instructed by the
message in the display and press the [START] key to begin printing. (The bypass tray
cannot be used for two-sided printing.) If "FORCED OUTPUT" is set to "ON", the job
will be printed on the paper in the machine even though if it is a different size.
6