Service manual

AL-2030/2040CS/2050CS SIMULATION, TROUBLE CODES 10 - 12
26 07 Machine conditions check [Function]
When this simulation is executed, the current machine setting is displayed.
[Operation] (AL-2050CS only)
20 Rear edge void setup [Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [ENTER]/[START] key to save
the setting.
[Operation]
The operation is similar to simulation 26-02.
30 CE mark support control
ON/OFF
[Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [ENTER]/
[START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
38 Cancel of stop at drum life
over
[Function]
When this simulation is executed, the current setup of the code number is displayed. Enter the
code number and press the PRINT switch to enable the setup.
[Operation]
The operation is similar to simulation 26-02.
39 Memory capacity check [Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
[Operation] (AL-2050CS only)
40 Polygon motor OFF time
setup (Time required for
turning OFF after completion
of printing)
[Function]
When this simulation is executed, the current setting is displayed. Enter the code number corre-
sponding to the desired setting and press [ENTER]/[START] key to save the setting.
[Operation]
The operation is similar to simulation 26-02.
Main
code
Sub
code
Contents Details of function/operation
CPM Copy quantity Remark
20 CPM 20
1) The machine setting is displayed.
26-07 CPM
20 CPM
Code number Setting Display item Remark
0 Rear edge void NO OFF
1 Rear edge void YES ON Default
Code number Setting Display item Remark
0 CE mark support control OFF OFF Default (100V series)
1 CE mark support control ON ON
Code number Setup
0 Stop at drum life over * Default (AL model)
1 Cancel of stop at drum life over
Code number Setting Remark
88 MBYTE
16 16 MBYTE
1) Memory capacity display
26-39 MEM.CHK
8 MBYTE
Code number Setting
Display item
Remark
AL-2050CS AL-2030/2040CS
0 0sec 0 SEC. 0
1 30sec 30 SEC. 30 Default
2 60sec 60 SEC. 60
3 90sec 90 SEC. 90