Service manual

AL-2030/2040CS/2050CS UNPACKING AND INSTALLATION 5 - 2

4. Unpacking

Be sure to hold the handles on both sides of the unit to unpack the

unit and carry it to the installation location.

5. Removing protective packing

materials

1) Remove all pieces of tape shown in the illustration below. Then

open the SPF/RSPF and remove protective materials. After

that, take out the bag containing the TD cartridge.

2) Release the scan head locking switch.

The scan head locking switch is under the document glass.

If the switch is locked ( ), the unit will not operate. Unlock the

switch ( ) as shown below.

To lock the scan head locking switch, hold up the catch in illus-

tration (A) and turn the center knob counter-clockwise 90

degrees until you hear a click.

6. Installing the TD cartridge

1) Open the multi-bypass tray, and then open the side cover.

2) Remove the CAUTION tape from the front cover and remove

the two protective pins from the fusing unit by pulling the strings

upward one at a time.

3) Push gently on both sides of the front cover to open the cover.

4) Remove the TD cartridge from the bag. Remove the protective

paper. Hold the cartridge on both sides and shake it horizontally

four or five times. Hold the tab of the protective cover and pull

the tab to your side to remove the cover.

5) Gently insert the TD cartridge until it locks in place while push-

ing the lock release button.

6) Close the front cover and then the side cover by pressing the

round projections near the side cover open button.

Caution: When closing the covers, be sure to close the front cover

securely and then close the side cover. If the covers are

closed in the wrong order, the covers may be damaged.

AL-2030

AL-2040CS/2050CS

(A)

Lock Unlock

Grasp here and turn in

the direction of the arrow.

CAUTION ta

Protective pins

4 or 5 times

Lock release button