Service manual

AL-2030/2040CS/2050CS UNPACKING AND INSTALLATION 5 - 7
10) Enter the IP address, subnet mask, and default gateway.
The settings in the above window are examples.
Be sure to ask your network administrator for the correct IP
address, subnet mask, and default gateway to be entered.
Note: When "Get IP Address Automatically" is selected, the IP
address may at times change automatically. This will
prevent printing. In this event, select "Assign IP Address"
and enter the IP address.
11) Click the "Next" button.
12) Click the "Yes" button in the confirmation dialog box that
appears.
Go to "LPR (TCP/IP) direct printing" step 11).
LPR (TCP/IP) direct printing
After step 1) - 7) on page 5-6.
8) Click the "Printer Driver" button.
If you have not set the IP Address, click the "Set the IP
Address" button first and go to step 8).
9) Read the message in the "Welcome" window and then click the
"Next" button.
10) Select "LPR Direct Print" and click the "Next" button.
11) The printer or printers connected to the network will be
detected.
Click the printer to be configured (the machine) and click the
"Next" button.
Note: If the machine’s IP address cannot be found, make sure
the machine is powered on, make sure the network cable
is connected correctly, and then click the "Search"
button.
12) In the window for setting the destination print port name, make
sure that ":lp" appears at the end of the IP address and click the
"Next" button.
Note: Any name can be entered in "Printer Port Name"
(maximum of 38 characters).
13) A window appears to let you check your entries. Make sure that
the entries are correct and then click the "Finish" button.
If any of the entries are incorrect, click the "Back" button to
return to the appropriate window and correct the entry.
14) Select the port you want to use with the machine, and click the
"Next" button.
15) Select whether or not you wish the printer to be your default
printer and click the "Next" button.
Follow the on-screen instructions.
Caution:
• If you are using Windows Vista and a security warning win-
dow appears, be sure to click "Install this driver software any-
way".
• If you are running Windows 2000/XP and a warning message
appears regarding the Windows logo test or digital signature,
be sure to click "Continue Anyway" or "Yes".
16) When "The installation of the SHARP software is complete."
appears, click the "OK" button.
17) When the "Finish" screen appears, click the "Close" button.
Note: After the installation, a message prompting you to restart
your computer may appear. In this case, click the "Yes"
button to restart your computer.
This completes the installation of the software.