Service manual

AL-2030/2040CS/2050CS UNPACKING AND INSTALLATION 5 - 11

C. Attachment method

Turn the main switch to the "OFF" position and remove the power

plug from the outlet.

1) Detach the RSPF.

Detach the RSPF from the copier and softly place it on top of

the original table as shown below.

2) Remove the rear cabinet.

<1> Unscrew the screw and remove the rear cabinet

shielding plate. (Save the screw.)

<2> Unscrew three screws and remove the rear cabinet. (Save

the screws.)

<3> Disconnect the connector of the RSPF, and remove the

RSPF from the machine.

3) Remove the rear cover for the document glass.

<1> Remove the two screws and then remove the right glass

holder.

<2> Slide the rear cover for the document glass to remove it.

<3> Remove the table glass.

4) Attach the Scanner condensation prevention mylar at the 3

positions on the rear side of the main unit as described below.

Note: The hole should be covered with the mylar.

Align the edge of the mylar to the R part (the yellow line in the

diagram below) so that the hole of the metal plate is covered as

much as possible.

Align the edge of the mylar to the R part (the yellow line in the

diagram below) so that the hole of the metal plate is covered as

much as possible.

Attach along the edge of the projection (the yellow line in the

diagram below).