Service manual

AL-2030/2040CS/2050CS DISASSEMBLY AND ASSEMBLY 8 - 21

G. Shutter solenoid

(1) Shutter solenoid unit removal

1) Remove the harness from the edge saddle.

2) Remove one screw.

3) Remove the shutter solenoid unit.

■ Note for reassembly

Install the paper feed solenoid under the state where the projection

of the paper feed planet arm is lower than the paper feed solenoid

lever.

(2) Shutter solenoid removal

1) Remove the paper feed solenoid spring from the shutter sole-

noid.

2) Remove the paper feed solenoid lever.

■ Note for reassembly

When assembling, use care so that the paper feed solenoid spring

does not extend out of the paper feed solenoid lever.

H. Pickup roller, take-up roller

(1) Paper feed unit removal

1) Remove the E-ring.

2) Slide the bearing.

3) Remove the stopper arm.

4) Release the paper feed shaft pressure release spring.

5) Remove the paper feed unit.

6) Remove the paper feed shaft release arm.

(2) Parts removal

1) Remove the E-ring.

2) Remove the resin E-ring.

3) Slide the shaft.

4) Remove the spring pin.

(3) Paper feed roller removal

1) Pull out the shaft.

2) Remove the clutch boss and the clutch spring from the pickup

roller.