Service manual

AL-2030/2040CS/2050CS DISASSEMBLY AND ASSEMBLY 8 - 22

(4) Pickup roller removal

1) Disengage one pawl.

2) Remove the pickup drive gear from the pickup roller.

I. Paper empty sensor

(1) Paper feed PG unit removal

1) Remove the harness.

2) Remove three screws.

3) Lift the front side, and remove the paper feed PG unit.

(2) Paper feed PG support plate removal

1) Remove one screw.

2) Slide and remove the paper feed PG support plate.

(3) Paper empty sensor removal

1) Disconnect one connector.

2) Remove the paper empty sensor.

J. PS roller

(1) Parts removal

1) Remove the gear.

2) Remove the pulley.

3) Remove the belt.

(2) Parts removal

1) Remove one screw.

2) Remove the earth wire.

3) Remove the E-ring.

4) Remove the bearing.

5) Open the scan plate.

■ Note for reassembly

Pass the earth wire through the hole to the outside of the frame,

then install parts.