Service manual

AL-2051 DISASSEMBLY AND ASSEMBLY 8 - 9
6) Remove each connector and four screws, and remove the MCU
PWB and network PWB. (The shape of the MCU PWB differs
depending on the model.)
7) Remove the PWB insulation mylar and remove the paper trans-
port detection sensor (POD).
8) Remove the screw, and open the upper paper guide.
9) Remove the roller, and remove the belt.
10) Disengage the pawl, and remove the roller knob.
11) Disengage the pawl, and shift the pulley and the bearing.
12) Remove the paper exit roller, and remove the belt, the pulley,
and the bearing.
2)
1)
3)
2)
2)
1)
1)
1)
1)
1)
1)
2)
1)
1)
1)
2)
1)
2)
1)
2)
3)
4)
1)
2)