Service manual

AL-2051 SIMULATION, TROUBLE CODES 10 - 13
26 42 Transfer ON timing control
setup
[Function]
[Operation]
Main
code
Sub
code
Contents Details of function/operation
When this simulation is executed, the currently set code number is displayed.
Enter the code number and press the [START] key, and the setting will be changed. (For any
number different from the following ones, the default time is automatically set.)
The adjustment can be made individually for each of the following modes.
<Paper lead edge adjustment table>
Note 1:
The default code ‘11’ for the transfer ON timing indicates a lapse of 236ms from PS release.
Note 2:
If the code “0” is selected, the setting is the same as the default setting ‘11’.
Note 3:
The transfer ON timing can be adjusted in increments/decrements of 2ms within the range of
236ms±20ms.
<Front/back surface of paper rear edge adjustment table>
* The default "50" of the transfer OFF timing indicates "210msec passed from PPD1OFF."
* The transfer OFF timing can be adjusted to 210msec ± 2ms.
Mode Display item Default Setting range
Front surface paper lead edge F-REAR 11 0 - 21
Front surface paper rear edge F-END 50 1 - 99
Back surface paper lead edge B-REAR 11 0 - 21
Back surface paper rear edge B-END 50 1 - 99
Code Setting Remark
00 msec
1 –20 msec
. . . . . .
10 –2 msec
11 0 msec Default
12 2 msec
. . . . . .
21 20 msec
Code Setting Remark
1 –98 msec
. . . . . .
49 –2 msec
50 0 msec Default
51 +2 msec
. . . . . .
99 +98 msec
1) Initial display
<Front surface lead edge setting>
2)[] [] key: Mode selection
3) [Numeric] key: Value entry
4) [ENTER]/[START] key:
Settles the entered value. The display is
shifted to the sub code input standby
menu.
26-42 TC ON TIMING
F-REAR 11( 0-21 )
26-42 TC ON TIMING
F-END 50( 1-99 )
26-42 TC ON TIMING
F-END 51( 1-99 )