User Manual

33
33
3
INSTALLATION
1
1
Set upSet up
Set upSet up
Set up
1
Remove the screw from the left side of the copier by rotating it in the
direction indicated by the arrow.
Save the screw because it will be used if the copier has to be moved
(
p. 132). Store the screw inside the front cover.
2
Remove the tape and the protective paper on the original table.
Do not remove this part with the front cover closed
Tape
Push gently on both sides of the front cover to open the cover.
3
Store the screw which has been removed in step 1 at the right side inside
the front cover.
4
After removing protecting material a, gently pull black protective paper b
and protective material c together to your side and remove them. Be
careful not to tear the protective paper during removal.
5
SUK 01 INSTALLATION LEO.p65 18/04/00, 12:183