User Manual

ManualsBrandsSHARP ManualsCopier / MFPAL-F880/FO-3800M

INITIAL SETTINGS

4444

About the Liquid Crystal DisplayAbout the Liquid Crystal Display

About the Liquid Crystal Display

The machine is equipped with a two-line liquid crystal display (LCD) on the

operation panel for displaying various messages and settings during operation.

This LCD can display up to 20 characters on each line. When the machine is

idle, the LCD shows the date, time, and the stand-by memory available.

Example:

Adjust the volume of both key beeps and alarm beeps (emitted at the end of

transmission and reception) using the procedure below.

Factory setting: 3 (MEDIUM)

StepStep

Step

Press these keysPress these keys

Press these keys

CommentsComments

Comments

1 “OPTION SETTING” will

appear in the display.

2 “BEEP VOLUME” will

appear in the display.

3 Press the

or key to

lower or raise the volume

to the desired level.

4 “STORED” will appear in

the display.

5 Press the

STST

OPOP

OP key twice

to exit.

FUNCTION

GHI

JKL

oror

ENTER

STOP

Adjusting the Beep Adjusting the Beep

Adjusting the Beep

olumeolume

olume

The

left and right arrowleft and right arrow

left and right arrow ( ) keys on the operation panel of the machine

are very useful for scrolling through the various function lists and settings.

Once you have pressed the

FUNCTIONFUNCTION

FUNCTION key, you can scroll through the ten

functions as desired. (See the Function mode at the top of the Quick Reference

Guide for the settings.) Pressing the

ENTERENTER

ENTER key chooses the displayed

function. For many of the function lists, you can then use the arrow keys again

to scroll through the settings.

Using the Arrow KeysUsing the Arrow Keys

Using the Arrow Keys

Note:Note:

Note: means this machine is in the Reverse Sending mode. It appears

when LCD shows “STAND-BY” or “SEND READY”.

STOP

SUK 06 INITIAL LEO.p65 17/04/00, 13:1444