Operating instructions

·
Before connecting the appliance to electrical
power supply, leave it to stand for about 4 hours,
To save shipping space and avoid damage of which will reduce the possibility of malfunctions
the unit during transportation, the door handle in the cooling system due to transport handling.
of this unit is shipped unassembled. Before
·
Clean the appliance thoroughly, especially in the
putting the unit into use you are kindly asked to interior (See Cleaning and Maintenance).
assemble the door handle as follows:
·
In case the interior accessories are not correctly
.
Locate the door handle and 2 screws attached placed, rearrange them as described in chapter
inside the cabinet, and prepare an appropriate "Description of the Appliance".
screwdriver.
.
With the 2 screws attached, fasten the door
Instructions for Use
handle onto the frame of the door panel as These instructions for use are intended for the user.
illustrated. Be sure that the screws must point They describe the appliance and correct operating
procedures for safe use .
SAVE THESE INSTRUCTIONS:
·
Tr
y
not to o
p
en the door too often, es
p
eciall
y
when
the weather is hot and humid. Once you open the
door , close it as soon as possible. This is
especially important if you have an upright model .
·
Ever
y
now and then check if the a
pp
liance is
sufficiently ventilated ( adequate air circulation
behind the appliance ).
·
Set the thermostat from higher to lower settings as
soon as possible (depends on how loaded the
appliance is, ambient temperatures etc.).
·
If the gasket is damaged or the door seal is poor,
energy consumption is substantially higher. To
restore efficiency, replace the gasket.
·
Always consider instructions stated in sections
Positioning and Energy Saving Tips, otherwise
the energy consumption is substantially higher.
Before Putting Into Use
Tips for Energy Saving
2
To Assemble Door Handle
to the holes on the frame of the door panel
when doing so.
Downloaded from www.vandenborre.be