Operating instructions

If you do not intend to use the appliance for long
periods of time, disconnect the power supply,
take out the contents and defrost and clean the
situated above the compressor, from where it
evaporates. 1.Pull out the power plug from wall socked. Use a
screw driver to loose the screw that holds the bulb
protective cover and then remove the cover.
2.Screw out the old bulb counter-clockwise.
3.Screw on a new bulb ( max. power 15W)
clockwise.
4.Replace the bulb protective cover.
Very important:
Be sure to disconnect power supply before you
change bulb.
agents as you may damage the surface.
Correct Step to Change Bulb:
the appliance.
Cleaning the Appliance
Do not use coarse or aggressive cleaning
outlet in the inner back wall into a drain pan
Maintenance and Cleaning
Automatic Defrosting of the
Appliance
compressor operation will defrost automatically
(when the compressor has cycled off) . Defrost
Ice build-up on the inner back wall during the
Switch Off the Appliance
When Not In Use
appliance. Leave the door slightly open.
7
liquid detergent. Plastic parts cannot be washed
There is no need to defrost the cooler , because
ice depositing on the inner back wall is defrosted
water , adding one or two spoonfuls of vinegar.
Disconnect the power supply before cleaning
automatically.
Wash the interior of the appliance with lukewarm
water will drain out passing through the drain
After cleaning, connect the appliance to power
supply and reload it.
Clean the exterior with water and detergent.
Remove the detachable accessories in the
in dishwashers.
interior of the appliance and clean with water and
Downloaded from www.vandenborre.be