User Manual
12
When Connecting Using Telnet
1 Click “Start” from the Windows desktop and select “Run”.
2 Enter “telnet 192.168.150.2” in the text box that opens up.
(If the IP address of the unit is 192.168.150.2.)
3 Click “OK”.
4 “User Name:” is displayed. Input the user name and press the return key.
(If a user name has not yet been set, just press the return key.)
5 “Password:” is displayed. Input the password and press the return key.
(If a password has not yet been set, just press the return key.)
6 Input “setup” and press the return key.
| SETUP MENU will be displayed.
S E T U P M E N U
[1]IP Address [2]Subnet Mask [3]Default Gateway
[4]User Name [5]Password
[6]RS-232C Baud Rate [7]Unit Name
[A]Advanced Setup [D]Disconnect All
[V]View All Setting [S]Save & Quit [Q]Quit Unchanged
setup>
• If the IP address has been changed, be sure to enter the correct IP address.
• User name and password are not set in the initial settings.
• If the user name or password is entered incorrectly three times, SETUP MENU will be quit.