Operation Manual, User's Manual

1-92
BEFORE USING THE MACHINELOADING PAPER
Setting orientation of the print side
The setting orientation varies for the print side of paper, depending on the tray used. For "Letter Head" and
"Pre-Printed", set the paper in the reverse orientation.
Place with the print side facing the direction indicated below.
Paper that cannot be used
Embossed paper
Tab paper
Special media for an ink jet printer
(fine paper, glossy paper, glossy film, etc.)
Carbon paper or thermal paper
Pasted paper
Paper with clips
Paper with fold marks
Torn paper
Oil-feed transparency film
Thin paper less than 55 g/m
2
(15 lbs)
Heavy paper as thick as 220 g/m
2
(80 lbs. cover) over
Irregularly shaped paper
Stapled paper
Damp paper
Curled paper
Paper whose print side or reverse side has been already printed on by this printer or multifunction device.
Paper with a wave-like pattern due to moisture absorption
Paper with creases
Paper with dust
Non-recommended paper
Iron-on transfer paper
Perforated paper
Tray In normal status With letter head or pre-printed paper set
Trays 1 - 4 Facing up Facing down
Bypass Facing down Facing up
When [Disabling of Duplex] is set for "Letter Head" or "Pre-Printed", set the print side in the same orientation as for the
ordinary operation.
To set [Disabling of Duplex]:
In "Settings (administrator)", select [System Settings] [Common Settings] [Device Control] [Condition Settings]
[Disabling of Duplex].