AN-SV100T Operation-Manual Installation-Manual GB
12
Attaching the Ceiling Mount to the Ceiling
When installed with the AN-TK201
Attach the ceiling mount to the ceiling.
Mounting bolt (M8-type)
Washer
First, lightly screw an installation bolt into the smallest hole and then proceed, doing the same
for the holes
, and . Once the position has been decided, fi rmly tighten all four bolts.
Use M8-type bolts. (Bolt type may vary depending on the method of installation.)
Use the washers supplied with the ceiling mount.
Caution
Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility
whatsoever if inadequate installation causes your projector or attached devices to fall out of
place.
•
•
•
•
AN-SV100T.indb12AN-SV100T.indb12 2011/05/2515:55:562011/05/2515:55:56