AN-SV100T Operation-Manual Installation-Manual GB
14
Attaching the Ceiling Mount to the Ceiling (Continued)
When installed with the AN-TK202
Attach the ceiling mount to the ceiling.
First screw a bolt into the hole (smallest hole) and tighten it enough to keep the mount in place.
Then, do the same for the holes
, and .
Position the four corners correctly, and then tighten all bolts fi rmly.
Use M8-type bolts. (Bolt type may vary depending on the method of installation.)
Use the washers supplied with the ceiling mount.
Caution
Ask your dealer or service shop to install the ceiling mount. Sharp will assume no responsibility
whatsoever if inadequate installation causes your projector or attached devices to fall out of
place.
•
•
•
•
To the dealer or serviceman
For the customer's safety, reinforce the
point of installation so that it is strong
enough to bear the weight of the whole
system before installing it.
Info
Only qualifi ed servicemen should install the
projector. Never let the customer install the
system by him/herself.
•
AN-SV100T.indb14AN-SV100T.indb14 2011/05/2515:55:572011/05/2515:55:57