AN-SV100T Operation-Manual Installation-Manual GB

17
Installing the Projector on the Ceiling Mount
Install the projector on the ceiling mount.
 Line up the cut-out parts on the installation adapter with the bottom
of the height-adjusting pole, and hang the projector on the pole.
Height-adjusting pole
Cut-out parts
Caution
Be sure the projector does not fall out of place.
Until properly anchored, the projector will remain freely suspended from the pole.
 Screw in the vertical-angle adjustment bolts enough that they do not
fall out of place (two on each the left and right sides).
Vertical-angle adjustment
bolts M6 (12 mm)
Vertical-angle adjustment
bolts M6 (12 mm)
Adjust the projector's vertical angle and then tighten the screws fi rmly.
•
•
Basic installation
For details on the correlation between projecting distance and display size, refer to the projector
operation manual.
AN-SV100T.indb17AN-SV100T.indb17 2011/05/2515:55:582011/05/2515:55:58