Specifications

20
5
Supplies and user maintenance
5
SUPPLIES AND USER MAINTENANCE
This chapter describes how to replace the TD cartridge and the drum cartridge and how to
check the total number of copies.
TD CARTRIDGE REPLACEMENT
The toner required ( ) indicator will light up when toner is needed. If copying is continued while
the indicator is lit, copies will gradually become lighter until the copier stops and the indicator
begins blinking. Replace the old TD cartridge by following the procedure given below.
●
After the copier stops, it may be possible to make a few more copies by taking
the TD cartridge out of the copier, shaking it horizontally, then reinstalling it. If
copying is not possible after this operation, replace the TD cartridge.
●
During long copy run of a dark original, the ready ( ) indicator may blink,
the indicator light up, and the copier stop, even though toner is left. The
copier will feed toner up to 2 minutes and then the ready ( ) indicator will
light up. Press the print ( ) key to restart copying.
1
Open the side cover while pressing the side cover open button.
Then, push gently on both sides of the front cover to open the cover.
2
Gently pull the TD cartridge out while pressing the lock release button. Dispose of the
old TD cartridge in accordance with local regulations.
Lock release button
Be sure to use only genuine SHARP parts and supplies.